8/19/2023 0 Comments Master reboot flying![]() Upgrade to the latest stable version of ChibiOS 21.11. INS_HNTCH_ENABLE,1 ← set this then refresh params to see the rest On the Settings page, click the Reboot button in the System. It is a mistake to think “I’m only testing, I don’t need these yet” This can be done for the skaarOS / the full Blue Pill / or per package. Try setting these to improve the GNSS performance Using one of the hard reset methods on Flyingvoice Flying Voice FWR9502 is safe and should not affect the device in any other way than it is supposed to. The dream is not just an incredibly designed and engineered transit-oriented master plan community where the residents of Anaheim and surrounding regions. There are many Auto Arm messagess, so you might want to investigate whatever the GCS is doing. In the final flight you do switch into Stabilise mode and almost lose control probably because of the wind.Ī lot of the time (in previous flights) is spent in Guided and Land, there are small sections of Loiter and Stabilise. The baro altitude doesnt support landing on a building. ![]() In addition to that, we need the certificates and optionally the kubeadm configuration file for easily restoring the master. Backup a single master As mentioned previously, we need to backup etcd. The copter may have been trying to use a wandering GPS position. In case of Master nodes which host ETCDs you need to be extra careful in terms of rolling upgrade of ETCD and backing up the data. ![]() Also if you look on the map it looks like you took off in the car park, but it was landing in the roof of a building according to the GPS position. The trouble is landing is not detected, so the copter thinks it should still be flying. After what appears to be a landing (even though there is no land detect) logging continues. I definitely dont see any reboot in-flight in that log. Ignore all below, it doesnt relate to Tim Boyles log. An attractive premise lies at the heart of Master Reboot, but cheap horror tactics let it down. Much appreciated the great help from the team here! I’d like to understand this so it doesn’t happen again. Video of the flight (note wind gusts was causing the barometer height to vary and GPS was not using RTK so the slight variation in position was expected).Īgain I can’t recreate.See link to zip file with: WeTransfer - Send Large Files & Share Photos Online - Up to 2GB Free It is obvious the GPS, IMU were being used to land the copter otherwise it would have been blown away. Looks like a reboot happened at 10m high and something clever kept control of the copter. The logs stop whilst in the air and doesn’t show the change in RC3IN or the mode change. Weather station nearby was reporting 48-65kph wind but I suspect it was less where I was. I increased throttle to decrease descent speed without response. I reduced throttle and the copter started to descend slowly at first then faster (looked like the max 300cm/s). Switched to RTL and noticed LEDs didn’t change colour and copter continued to hover. You can reset Sentry to factory settings by powering on the device and then press and hold the power button. Tried a hover flight in strong wind today (48kph) in PosHold and it seemed to be responding to controls ok. DOES SENTRY INCLUDE A FLIGHT DATA RECORDER. I had a reboot whilst disarmed (evident by beeping motors) and I couldn’t recreate it
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |